How to repinn?
Extreme HDF Member
Joined: Nov 2007
Posts: 14,670
Likes: 139
From: East of the Sun, West of the Moon
you should be able to stick a very small pick or paper clip inside the back of the connector to release the pins and they'll slide out. Once you get the pins out, make sure to bend out the little tabs slightly so they'll "click" back into place when inserting in the right slots.
I tried a paper clip. It's super tight but I found a super small cotter pin that may work. It's also nice to know to go in from the back. One question is the little tab on the bottom or top?
Extreme HDF Member
Joined: Nov 2007
Posts: 14,670
Likes: 139
From: East of the Sun, West of the Moon
I use a jewelers screwdriver.. the small one fits perfectly in there.
the little locking tab on top of the metal pin should be opposite the slit in the metal connector end.
the little locking tab on top of the metal pin should be opposite the slit in the metal connector end.
Extreme HDF Member
Joined: Nov 2007
Posts: 14,670
Likes: 139
From: East of the Sun, West of the Moon
same connector and me, I would have done exactly what you did.
Thread
Thread Starter
Forum
Replies
Last Post
