T-Bar Mount Question
Thread Starter
|
Seasoned HDF Member
Joined: Oct 2007
Posts: 10,946
Likes: 820
From: Nevada
T-Bar Mount Question
I am considering T-bar handlebars for my 2003 Low rider. Would appreciate it if someone will tell me the maximum rise and pull back I can use with the stock cables and wiring.
Cruiser
Joined: Sep 2014
Posts: 230
Likes: 0
From: Virginia
the 03 has much less cable/wire than the new bikes. When I went to 10 inch t bars on my 05 FXDL, I had to swap everything but my throttle lines. I'd say that you could probably fit 8 inch t bars, but I'm not even certain that would work. Its not worth the swap honestly unless you change the wires and cables.
Ultimate HDF Member
Joined: May 2008
Posts: 6,642
Likes: 48
From: Ogden, UT
The answer to your question also depends on how you like to see your cables dressed, which is why 2 of the answer seem to contradict each other.
Do you want them to parallel the bars or are you ok with them looking stretched to get from end to end?
On my 01 LR I swapped cables to go to 8" t-bars just because I wanted the cables "hidden" by routing along the bars.
Do you want them to parallel the bars or are you ok with them looking stretched to get from end to end?
On my 01 LR I swapped cables to go to 8" t-bars just because I wanted the cables "hidden" by routing along the bars.
Thread
Thread Starter
Forum
Replies
Last Post
