Crank no fire
Thread Starter
|
Stage II
Joined: Sep 2020
Posts: 2
Likes: 0
From: NM
Crank no fire
I have a 2002 FXDWG engine turns over but not getting any fire. The plug to the coil has 3 prong connector, getting power to center, but both sides of it I get no ground. It ran fine when I took it for a ride earlier that day, but when I went to ride it later I got no spark. Battery is good. Can anyone give me any ideas on this
Club Member
Joined: Sep 2010
Posts: 15,430
Likes: 7,124
From: Beyond Fucital
I'll assume it's an aftermarket ignition module.
So there should be 2 white wires on the center coil post. Positive from the On switch and feed to ignition module in the nosecone.
The other 2 coil posts get a ground signal from the ignition module.
So there should be 2 white wires on the center coil post. Positive from the On switch and feed to ignition module in the nosecone.
The other 2 coil posts get a ground signal from the ignition module.
Supporter
Joined: Jan 2007
Posts: 15,788
Likes: 5,623
From: along the shore of Mishigami
The ignition is triggered by the crank position sensor signal, it's the little black piece sticking out of the crankcase near the oil filter. Try unplugging the sensor clean the connector put it back together and try it. Some have tried to read the ohms on the sensor plug. Others may chime in on this or look it in the search.
Club Member
Joined: Sep 2010
Posts: 15,430
Likes: 7,124
From: Beyond Fucital
The ignition is triggered by the crank position sensor signal, it's the little black piece sticking out of the crankcase near the oil filter. Try unplugging the sensor clean the connector put it back together and try it. Some have tried to read the ohms on the sensor plug. Others may chime in on this or look it in the search.
Thread
Thread Starter
Forum
Replies
Last Post
twistedorgifted
Ignition/Tuner/ECM/Fuel Injection
0
May 29, 2012 05:40 PM
