Not sure if this video has been posted before, but I found it interesting
Thread Starter
|
Road Master
Joined: Jun 2008
Posts: 789
Likes: 2
From: Battle Creek, MI
Not sure if this video has been posted before, but I found it interesting
For those considering doing their own cam swap, but have never taken the cover off the case even, this at least exposes you tot he process involved and what you are looking at when you dig in.
http://www.youtube.com/watch?v=MPRbpbGq0-k
http://www.youtube.com/watch?v=MPRbpbGq0-k
Road Master
Joined: May 2007
Posts: 953
Likes: 8
From: Central Oregon
Thanks for the link.
After seeing how much pressure he was applying to the parts you could tell he wasn't using any "thermal help" when doing the project. I always freeze the part going into and heat the part receiving the first part. The parts mostly fall together doing this way.
After seeing how much pressure he was applying to the parts you could tell he wasn't using any "thermal help" when doing the project. I always freeze the part going into and heat the part receiving the first part. The parts mostly fall together doing this way.
Cruiser
Joined: Sep 2007
Posts: 204
Likes: 0
From: Santa Clara, CA
how about this pod cast from Revolution Performance.
http://www.youtube.com/watch?v=Rl0iAHqm090
He talks about going to a gear driven cam setup in 2008 Harleys. Has slight bit of info concerning differences between the 99-06 bikes and the 07-08 bikes.
James
http://www.youtube.com/watch?v=Rl0iAHqm090
He talks about going to a gear driven cam setup in 2008 Harleys. Has slight bit of info concerning differences between the 99-06 bikes and the 07-08 bikes.
James
Thread
Thread Starter
Forum
Replies
Last Post
