Us short guys like the mids. lol

 

I'm only 5'10. The forwards on my Street Bob felt a little too much of a stretch at first but I guess I've gotten used to them. The low barebones seat makes me fit the bike perfectly and I feel like I'm riding in the bike instead of on it. Too bad the damn seat hurts my *** like Oprah hurts fried chicken.

 

+a million to that!!

 

Muahahahahaha!! LMAO @ PIB! hahahaha that was halarious.. not sure why, but I had a good laugh to that.

And what do I have planned? Well.. what fun would it be if I told everyone when I can keep some of you in suspense!

 

if you need the trq. specs for that 113 kit let me know,i"ll look em up.

 

hahahahaha

 

.
.
.



Here ya go kid. I believe the (you need 5) sealing bolts (#1) were left off an earlier posted list.

My list may be incomplete also, so *doublecheck* me....

have a good look at the "PIAB" and the IPB race while you are in there.

Also, (last picture), have a good look at the chain tensioner.

(last picture), if yours looks like the one on the bottom,
replace with the one pictured on the top.............

.
.

.
.

.
.
.
.
below,
.......the tensioner on top is part # 39929-06A..... (good)
.......original equipment also shown 39929-06..... (not good)
.
.

.
.
above, you see the -06A component is considerably beefed up.
.
.

.
.
.
.

 

Just put the pegs on. that is what I do. I do it for long road trips to give my feet someplace else to put them.

Then when you are done, just remove the pegs.

 

i would definatlly replace the IPB while in that far just to be safe... bearings have a tendancy to fail after being "messed with"..