Putting mid controls back on this weekend/next week - Gaskets/seals?
Dyna Glide ModelsSuper Glide, Super Glide Sport, Super Glide Custom, Dyna Glide Convertible, Super Glide T-Sport, Dyna Glide Police, Dyna Switchback, Low Rider, Street Bob, Fat Bob and Wide Glide.
Putting mid controls back on this weekend/next week - Gaskets/seals?
Hey guys,
I'm putting my mid controls back on either this weekend or next week. My question is, what gaskets/seals do I need to buy to replace? Just trying to get everything ready for when I get this going.
primary seal,starter oring,gasket between engine and primary,primary cover gasket,small round gasket that goes over shifter shaft. better replace the primary bearing while its apart. do you have the shorter trans shifter arm the mids use??
primary seal,starter oring,gasket between engine and primary,primary cover gasket,small round gasket that goes over shifter shaft. better replace the primary bearing while its apart. do you have the shorter trans shifter arm the mids use??
I have thought about replacing the IPB, but no sense in replacing something that aint broke and runs fine. I haven't had any issues with it yet (knock on wood) but I'm sure when the time comes, I'll do it. But for now, its staying.
I do have the short shifter arm. SuperFastGlide was gracious enough to send me everything I needed. Thanks for the reply!
Mids were one of the reasons I bought my FXDC. It's nice to stand up once in a while or lift your *** off the seat when going over railroad tracks or other large bumps. Can't do that with forwards. No comparison when running through the twisties either.
Actually I can lift my *** off the seat with forwards just not longer than a couple seconds. I've always owned bikes with mids except the last 2 bikes. I didn't think I'd like forwards at first but damn, I love them now.