Help With PC 5 Maps Please....
Thread Starter
|
Advanced
Joined: Oct 2009
Posts: 91
Likes: 1
From: England
Help With PC 5 Maps Please....
Guys..
I have a little issue, I really don`t think there is an accurate answer to this, so I`d just be grateful for your views..
My setup is this..
SE 103 Big Bore Kit without cams..
SE A/C..
Big Radius 2-2..
The dealer has installed map number M15-005-003.
This does not take into account the 103 Cu In conversion..
There isn`t a map available for my exact set up..
The nearest map is M814-008, for a 2008 Dyna, however this cannot be installed as it is from a PC 3...
Map M15-005-013 is close, however this includes SE cams.
As I said in a previous thread, I intend to have a dyno tune once the engine is run in, however I would like it running as close to how it should be for now..
What are your thoughts on this guys.
Is anyone out there running the same set up as me that can provide me with the values so I can dial them in on my PC 5?
Thanks in advance.
Regards.
I have a little issue, I really don`t think there is an accurate answer to this, so I`d just be grateful for your views..
My setup is this..
SE 103 Big Bore Kit without cams..
SE A/C..
Big Radius 2-2..
The dealer has installed map number M15-005-003.
This does not take into account the 103 Cu In conversion..
There isn`t a map available for my exact set up..
The nearest map is M814-008, for a 2008 Dyna, however this cannot be installed as it is from a PC 3...
Map M15-005-013 is close, however this includes SE cams.
As I said in a previous thread, I intend to have a dyno tune once the engine is run in, however I would like it running as close to how it should be for now..
What are your thoughts on this guys.
Is anyone out there running the same set up as me that can provide me with the values so I can dial them in on my PC 5?
Thanks in advance.
Regards.
Thread
Thread Starter
Forum
Replies
Last Post
