Turn signal stuck on?
Thread Starter
|
Cruiser
Joined: Jun 2010
Posts: 210
Likes: 2
From: South East PA / DE
Turn signal stuck on?
After 150 miles today my left turn signal came on but solid not blinking. It will not turn off. Both front and black are on solid.
Before I dig in I was wondering if anyone has a good starting point?
Tough to search I am on the road and somewhat limited
Before I dig in I was wondering if anyone has a good starting point?
Tough to search I am on the road and somewhat limited
Tourer
Joined: Apr 2008
Posts: 264
Likes: 0
From: Las Vegas
It sounds like a short in the wiring, Start at the signal housing and work from there.
I would move the signal wire around and see if there is a change. If there is that is probably where the short is.
I would move the signal wire around and see if there is a change. If there is that is probably where the short is.
Thread Starter
|
Cruiser
Joined: Jun 2010
Posts: 210
Likes: 2
From: South East PA / DE
Thanks. Traced the problem back to my rear turn signals.
Awhile back I replaced my stock brake light and relocated the circuit board. Two weeks ago I installed air shocks. Well it lowered the rear and rubbed thru causing a short.
Fixed the wiring and installed the stock tail light for the remainder of the riding season.
Guess I either have to go back to stock shocks, or reconfigure wiring.
Anyway thanks for the tip.
Awhile back I replaced my stock brake light and relocated the circuit board. Two weeks ago I installed air shocks. Well it lowered the rear and rubbed thru causing a short.
Fixed the wiring and installed the stock tail light for the remainder of the riding season.
Guess I either have to go back to stock shocks, or reconfigure wiring.
Anyway thanks for the tip.
Thread
Thread Starter
Forum
Replies
Last Post
bout3fitty
Ignition/Tuner/ECM/Fuel Injection
4
Jun 11, 2014 11:46 PM
