How to wrap a 2-1 exhaust?
Thread Starter
|
Banned
Joined: Jun 2009
Posts: 476
Likes: 0
How to wrap a 2-1 exhaust?
Sorry if this has been answered but I could nto find the exact question/answer via search....
I just ordered some DEI Titanium wrap. Can you guys give your input on how best to wrap a 2 into 1 pipe? Bub Lakester 2-1. I know you start from the muffler end and work your way towards the engine, but what I'm unsure of because it's a 2 into 1 is exactly where I should start the wrap.
Do I just treat both the top and bottom as seperate headers, then do an additonal wrap on part where they both meet (that doesn't seem right though)....
Or do I start where the 2-1 meets, wrap that part, then continue up either the top or bottom header, then once done separately wrap the other header?
Closed by Admin at the request of the Original Poster - Grover #2 Admin
I just ordered some DEI Titanium wrap. Can you guys give your input on how best to wrap a 2 into 1 pipe? Bub Lakester 2-1. I know you start from the muffler end and work your way towards the engine, but what I'm unsure of because it's a 2 into 1 is exactly where I should start the wrap.
Do I just treat both the top and bottom as seperate headers, then do an additonal wrap on part where they both meet (that doesn't seem right though)....
Or do I start where the 2-1 meets, wrap that part, then continue up either the top or bottom header, then once done separately wrap the other header?
Closed by Admin at the request of the Original Poster - Grover #2 Admin
Last edited by neocontra; Feb 5, 2011 at 10:27 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Slick
Ignition/Tuner/ECM/Fuel Injection
0
May 20, 2008 12:31 PM
