LED tail light help please
Thread Starter
|
Intermediate
Joined: Jul 2012
Posts: 46
Likes: 1
From: Good Thunder Mn.
LED tail light help please
I wired up some led tail lights from a rocker, on my wide glide. The lights are running lights, blinker, and brake in one. I have everything working, but if you have a blinker on, and then hit the brakes, the led tail light stops blinking, but the front keeps blinking. Any ideas? Is this what a load equalizer is for?
Ultimate HDF Member
Joined: Apr 2008
Posts: 5,384
Likes: 12
From: Out on Deranged
You need a run turn stop module so that the light on the side your turning will keep blinking. Kuryakyn makes them for one, J&P has them in stock. Easy plug and play under the seat, no more than 40$ I think.
Elite HDF Member
Joined: Aug 2006
Posts: 3,759
Likes: 1
From: Republic of Texas
They're LEDs.
Usually, the lack of an equalizer will speed up the flash cadence. If only one end (front OR rear are changed, the flash will speed up a bit, but still be useful.
Usually, the lack of an equalizer will speed up the flash cadence. If only one end (front OR rear are changed, the flash will speed up a bit, but still be useful.
Road Master
Joined: Feb 2013
Posts: 993
Likes: 1
From: columbus, ohio
I just put led in the rear only. They work perfect. I wastold because or the dual filament that u have to use 1157 vs 1156. The 57 has two contact points on the base vs 1 on the 56. Like I said, the ones I got work perfect. 13 streetbob btw.
Thread Starter
|
Intermediate
Joined: Jul 2012
Posts: 46
Likes: 1
From: Good Thunder Mn.
They blink fine, and running lights work, the blinker just stops blinking when I hit the brake. The tail lights I used are 2 circuit, so I'm not sure if a stop run module will work.
Thread
Thread Starter
Forum
Replies
Last Post
GoOrdnance
Ignition/Tuner/ECM/Fuel Injection
4
May 17, 2016 11:42 AM
fogey47
Tri Glide, RG3 & Freewheeler Models
41
Oct 26, 2013 07:30 AM
