Cv help!!!
Thread Starter
|
Intermediate
Joined: Nov 2009
Posts: 30
Likes: 0
From: Washington State
Cv help!!!
Please help!!!
I removed my CV to do some pre-fit, unrelated stuff. Now, after I re-installed the carb, my bike won't run! What the hell?!?! I didn't make any changes or adjustments to my carb: Just remove, then re-install! What did I do??
My bike starts, but won't idle and it seems to be running very rich. I don't know, just a guess...
HEEEEELLLLLPPPPPPP!!!!!!
I removed my CV to do some pre-fit, unrelated stuff. Now, after I re-installed the carb, my bike won't run! What the hell?!?! I didn't make any changes or adjustments to my carb: Just remove, then re-install! What did I do??
My bike starts, but won't idle and it seems to be running very rich. I don't know, just a guess...
HEEEEELLLLLPPPPPPP!!!!!!
Last edited by DCON; Nov 28, 2009 at 10:05 PM.
Thread Starter
|
Intermediate
Joined: Nov 2009
Posts: 30
Likes: 0
From: Washington State
Thanks Kirby!
I took off the carb and intake and noticed that I didn't have the CV properly seated in the intake's gasket. I reinstalled everything and POOF! Could this cause a vacuum leak this bad?
Anyway, all is now good.
I need to go ride...
I took off the carb and intake and noticed that I didn't have the CV properly seated in the intake's gasket. I reinstalled everything and POOF! Could this cause a vacuum leak this bad?
Anyway, all is now good.
I need to go ride...
Thread
Thread Starter
Forum
Replies
Last Post
