Wego file
Thread Starter
|
Tourer
Joined: Jul 2006
Posts: 298
Likes: 12
From: Villa Rica, Georgia
The only problem I is getting the rpm right. I have the pulse per revs set at .5. On that run I think I topped out around 5000rpm, never made it to 6000rpm. I got my ignition set up for single fire and the wire from the wego on my coil for the rear cylinder.
Seasoned HDF Member
Joined: Mar 2010
Posts: 20,960
Likes: 7,487
From: Poolville
How did you open the file.. I still cannot....
Trending Topics
Seasoned HDF Member
Joined: Aug 2008
Posts: 5,064
Likes: 2,092
From: Ohio
20171721 file loaded, had to take a picture, couldn't get it to copy. Look in the upper corners
Just rechecked, also a 6314 rpm's in there after reloading it again
Just rechecked, also a 6314 rpm's in there after reloading it again
Last edited by 1997bagger; Jan 26, 2019 at 11:55 PM.
Seasoned HDF Member
Joined: Aug 2008
Posts: 5,064
Likes: 2,092
From: Ohio
Loaded it to documents, opened Wego Log, clicked on documents opening a drop menu of download, click on download and drop down menu of the loaded file is there, click on 20170721 file to load to the Wego graph
Tourer
Joined: Mar 2009
Posts: 406
Likes: 122
From: Iowa
You have to have the Wego Log software installed on your computer to display the file as a graph.
Without the Wego Log software installed on your computer, the zip file extracts to a text file that makes no sense and doesn't show any graphed results.
You can supposedly get the software from this website:
http://www.daytona-sensors.com/
I took a quick look and I think you can download the software from the choices under the "Tech Center" header, but I wasn't able to tell easily which software was the "Wego Log" software needed.
Without the Wego Log software installed on your computer, the zip file extracts to a text file that makes no sense and doesn't show any graphed results.
You can supposedly get the software from this website:
http://www.daytona-sensors.com/
I took a quick look and I think you can download the software from the choices under the "Tech Center" header, but I wasn't able to tell easily which software was the "Wego Log" software needed.