New clutch cable suggestions
:: RIMSHOT!!! ::
I really can't say enough good things about them. I've got Barnett's (clutch and throttle) on both my bikes. When I built my Sportster, I called them up and they put the actual cable assembly guy on the phone. We discussed what I was doing, gave him the measurements, and he was all set. After I got the cables, I discovered that I had screwed up measuring the clutch side. Way, way short. You might put some blame on Barnett since I suppose he should have known that the length of my throttle cable was so different from my clutch, but then I should have known that too.
Anyway, called them up, they said no problem, I sent back the dud, they sent a new one, and everything worked perfectly. Really couldn't have been a smoother experience.
They came across as good people running an honest, small business. Those are the kinds of folks I'm happy to support.
Dirt don't hurt
Joined: Jan 2011
Posts: 21,065
Likes: 4,561
From: Haslet Texas
That is what is used to connect your cable to your clutch lever.
Thread Starter
|
Road Warrior
Joined: Apr 2018
Posts: 1,347
Likes: 820
From: Moneta, Virginia
I replaced it this evening and rerouted the cable through the nacelle and eliminated the clamp.
I would guess Barnetts claim of a 40% improved efficiency is true... much smoother operation.
I would guess Barnetts claim of a 40% improved efficiency is true... much smoother operation.
Thread
Thread Starter
Forum
Replies
Last Post
