Ring and pinion replacement
Thread Starter
|
Stage II
Joined: Nov 2016
Posts: 2
Likes: 0
From: Washington State
Ring and pinion replacement
'97 Fat boy broke the ring and pinion. I'm trying to find a kit that I can use my OEM large coupler. I don't want to remove the starter(again). I see Compu-Fire kits with the ring gear and pinion and Evolution kits with the same. Evolution said I need to use their jackshaft assbly but it has the smaller coupler for the starter and as I said I don't want to remove the starter again. Which of these kits will work with my original jackshaft and large coupler(10 T)? I'm wanting to go 10/84 as I recently installed an engine with 10 to 1 and the starter clutch immediately went then the gears in succession.
Thanks
Thanks
HDF Community Team
Joined: Jan 2020
Posts: 1,434
Likes: 800
From: Colorado
Seasoned HDF Member
Joined: Aug 2008
Posts: 5,070
Likes: 2,112
From: Ohio
http://images.rolliesspeedshop.com/pdf/CF-54002.pdf
Remove the long pinion bolt to remove the old pinion, install new pinion, put the bolt back in. If you decide to pull the coupler out make sure you note the offset of the c-clip, the back side of the coupler slides over the starter output shaft, starter doesn't need pulled to do this. I have the same ring gear set
Remove the long pinion bolt to remove the old pinion, install new pinion, put the bolt back in. If you decide to pull the coupler out make sure you note the offset of the c-clip, the back side of the coupler slides over the starter output shaft, starter doesn't need pulled to do this. I have the same ring gear set
Seasoned HDF Member
Joined: Mar 2010
Posts: 21,003
Likes: 7,535
From: Poolville
http://images.rolliesspeedshop.com/pdf/CF-54002.pdf
Remove the long pinion bolt to remove the old pinion, install new pinion, put the bolt back in. If you decide to pull the coupler out make sure you note the offset of the c-clip, the back side of the coupler slides over the starter output shaft, starter doesn't need pulled to do this. I have the same ring gear set
Remove the long pinion bolt to remove the old pinion, install new pinion, put the bolt back in. If you decide to pull the coupler out make sure you note the offset of the c-clip, the back side of the coupler slides over the starter output shaft, starter doesn't need pulled to do this. I have the same ring gear set
Exactly...
Thread
Thread Starter
Forum
Replies
Last Post
masksqueeze
Primary/Transmission/Driveline/Clutch
2
Oct 17, 2008 08:56 AM