Evo bends 4 pushrods
Road Captain
Joined: Sep 2012
Posts: 675
Likes: 32
From: Massachusetts
NOT necessarily.
I bent 2 when I ripped out both right side headstuds out of the cases @ ~5500ish RPM. valves were A OK. head gasket blew out the whole right side, pushrods jumped and wailed the hell out of the tubes (i saved the tubes somewhere...clips went flying and never recovered em)
this story is DEFINITELY bullshit...but a valve def isnt the ONLY way to bend a pushrod (that being said, i took the ole 80" further than most do)
Seasoned HDF Member
Joined: Mar 2010
Posts: 21,004
Likes: 7,539
From: Poolville
NOT necessarily.
I bent 2 when I ripped out both right side headstuds out of the cases @ ~5500ish RPM. valves were A OK. head gasket blew out the whole right side, pushrods jumped and wailed the hell out of the tubes (i saved the tubes somewhere...clips went flying and never recovered em)
this story is DEFINITELY bullshit...but a valve def isnt the ONLY way to bend a pushrod (that being said, i took the ole 80" further than most do)
I bent 2 when I ripped out both right side headstuds out of the cases @ ~5500ish RPM. valves were A OK. head gasket blew out the whole right side, pushrods jumped and wailed the hell out of the tubes (i saved the tubes somewhere...clips went flying and never recovered em)
this story is DEFINITELY bullshit...but a valve def isnt the ONLY way to bend a pushrod (that being said, i took the ole 80" further than most do)
Thread
Thread Starter
Forum
Replies
Last Post
Jackie Paper
The General Motorcycle Forum
1
Oct 28, 2012 11:16 PM
