looking to go BIG
Thread Starter
|
Stage II
Joined: Nov 2007
Posts: 2
Likes: 0
looking to go BIG
Hi everyone I'm new here so want to say hi. Anyway, I'm getting ready to build my deuce its a 03 with SE II pipes, SE AC and thats it. I have got my SE cylinders, dome SE forged high compression pistons, and looking for a good cam to porvide good low and middle range power with good street manners and reliably for everyday riding.
thanks
thanks
Road Captain
Joined: Feb 2005
Posts: 611
Likes: 21
From:
RE: looking to go BIG
Your compression is going to be around 9.6:1 according to SE cataloge unless you deck heads. This is going to be at the low end for the 570 and coupled with smaller ports afraid the 570 would fall flat. You might think about Andrews 26 in a gear or maybe 31's. If going to all this trouble it would be a shame not to get a street port done to your heads at least. I love the 570 but need 10:1 or will be flat on low end.
Road Master
Joined: May 2007
Posts: 851
Likes: 5
From: Mitchellville, Ia.
RE: looking to go BIG
I agree with Jlockhart that the compression should be increased to around 10 to 1 and the quench should be set at around .035 at the same time. If going to gear drive I like the new RR525 cam. Great torque cam.[/align]
Thread
Thread Starter
Forum
Replies
Last Post
