mukuni carb
Thread Starter
|
Tourer
Joined: Mar 2012
Posts: 352
Likes: 0
From: Texas
mukuni carb
can someone tell me what kind of intake Mukuni uses stock or can i use S&S?
Im and S&S person and out of all my bikes i have never had a mukuni but a friend swears if i run it ill never change so he gave me a new one.. So i am going to check it out just dont have intake except S&S and CV!!!
Im and S&S person and out of all my bikes i have never had a mukuni but a friend swears if i run it ill never change so he gave me a new one.. So i am going to check it out just dont have intake except S&S and CV!!!
Sponsor
Joined: Dec 2007
Posts: 12,084
Likes: 829
An S&S spigot-style intake manifold, has a 1.780" I.D., where it mates to the cylinder head, and this is great, as long as the cylinder head has been ported to take advantage of the increased plenum volume, except
the un-touched OE cylinder head has a port I.D. of about 1.630".
The in-coming charge is going to slam into a wall, all around the outside edge.
The OE CV manifold, will work for your new-found 42 Mik.
Scott
the un-touched OE cylinder head has a port I.D. of about 1.630".
The in-coming charge is going to slam into a wall, all around the outside edge.
The OE CV manifold, will work for your new-found 42 Mik.
Scott
Thread Starter
|
Tourer
Joined: Mar 2012
Posts: 352
Likes: 0
From: Texas
Thanks for info just picked up S&S carb been running them for years and ill just stick with it..The mukuni was givin to me and i dont really care to figure it out when i got the S&S down...
But like i said thanks again..
But like i said thanks again..
Thread
Thread Starter
Forum
Replies
Last Post
