Right hand case bearing modification
Thread Starter
|
4th Gear
Joined: Nov 2009
Posts: 8
Likes: 0
Right hand case bearing modification
My Flathead a (1946WL) on the right hand case the (pinion shaft) only has one set of bearings on the left case (sprocket shaft) has two sets of bearings.
Isn’t their a modification to make the right side case a dual bearing? If so how do I go about doing this modification?
Any part numbers and a step by step procedure on how to do this would be much appreciated.
Isn’t their a modification to make the right side case a dual bearing? If so how do I go about doing this modification?
Any part numbers and a step by step procedure on how to do this would be much appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
