windshield RE-COATING, not refinishing by buffing.
Seasoned HDF Member
Joined: Mar 2010
Posts: 38,668
Likes: 6,460
From: Honah Lee
If it a tint on the front of a Harley one, I do not think so. Someone stuck a flyer on mine with a piece of tape. The thin laminate tint came off with the tape. Harley sales just the shield for most.
Fore me, it was cheaper to get a unused take off off eBay . No mare silly tint either. You look over it and the untinted is a lot less noticeable.
Fore me, it was cheaper to get a unused take off off eBay . No mare silly tint either. You look over it and the untinted is a lot less noticeable.
Stellar HDF Member
Joined: Nov 2015
Posts: 2,726
Likes: 717
From: Pennsyleffinvania
Go to the "Detailing" section of the forum and find out how to take care of the bike. PWashing is a no, no in my book. Too much likelihood of injecting H2O and debris into places they don't belong. Good luck.
Seasoned HDF Member
Joined: Jun 2010
Posts: 9,332
Likes: 3,874
From: Upstate New York
This right here. I wonder how many of the cases of premature wheel bearing failure I read about came from bikes that were pressure washed. The high pressure wand can easily penetrate bearing seals and other places water should never go.
Thread
Thread Starter
Forum
Replies
Last Post
