custom indicator issue????
Thread Starter
|
Intermediate
Joined: Aug 2008
Posts: 46
Likes: 0
custom indicator issue????
I've attached two photos showing the indicator and the connecters. this indicator is on a 2006 Swift Punisher. The original control module for the turn signals, brake lights, horn and other accessories went bad and I had to replace the entire wiring harness with a thunder-heart harness. I can't seem to get the indicator lights for the turn signal, high/low, neutral and oil pressure. Did work when hooking up, but I think I may have burned them out. I can't figure out how to remove the indicator from the triple tree. Anybody know who makes this unit and how to remove it?
Thanks!
Ben Herr
2 Wheel Creations
Thanks!
Ben Herr
2 Wheel Creations
Extreme HDF Member
Joined: Nov 2007
Posts: 14,670
Likes: 139
From: East of the Sun, West of the Moon
ah the joys of custom bikes. :-)
have you checked that your indicators are grounded well?
can you see the bottom side of the indicator plate inside the triple tree?
have you checked that your indicators are grounded well?
can you see the bottom side of the indicator plate inside the triple tree?
Thread
Thread Starter
Forum
Replies
Last Post
Northern Cowboy
Electrical/Lighting/Alarm
4
Jul 16, 2015 07:36 AM
apetterez
Electrical/Lighting/Alarm
2
Dec 28, 2014 09:32 AM
toddzilla
Ignition/Tuner/ECM/Fuel Injection
3
May 14, 2006 10:30 PM
