new member and dyno
Thread Starter
|
Advanced
Joined: Jul 2015
Posts: 82
Likes: 4
From: Prescott AZ
new member and dyno
Hi
Just joined the forum have a 2015 Street Glide Special, it is completely stock and I am going to do a little work on it soon headers air filter and TTS Mastertune so I am going to get it on the dyno tomorrow I am at 5000ft above sea level any ideas what it will make. The shop I am using figures 8 to 10 HP loss from sea level to 5000 Ft. It is pretty sluggish and hope the work I am having done will wake it up a little.
Bob
Just joined the forum have a 2015 Street Glide Special, it is completely stock and I am going to do a little work on it soon headers air filter and TTS Mastertune so I am going to get it on the dyno tomorrow I am at 5000ft above sea level any ideas what it will make. The shop I am using figures 8 to 10 HP loss from sea level to 5000 Ft. It is pretty sluggish and hope the work I am having done will wake it up a little.
Bob
Thread Starter
|
Advanced
Joined: Jul 2015
Posts: 82
Likes: 4
From: Prescott AZ
stock dyno #'s
Well here is a print out from today's runs stock, the numbers do not look bad for 5000 above sea level but the uncorrected number was just over 60 hp. The next mod is going to be CVO mufflers re cored with Fulsac 2 ins baffles an air filter and a TTS Master tuner, I ordered a Jackpot header through Patrick Racing and hope it will be here tomorrow as they promised it would ship Monday. They have already modified the mufflers for me and just waiting on the header. These guys are really good and know what they are doing I will do a 107 in a month or so and have them port the heads.
Bob
Bob
Thread Starter
|
Advanced
Joined: Jul 2015
Posts: 82
Likes: 4
From: Prescott AZ
Update
Picked up the bike from PR yesterday and put 150 or so miles on it today, I am a very happy camper the bike is so much better it has torque now when you roll into it between 2 and 4 thousand the attached dyno sheet does not do it justice to what I am feeling riding the bike instant throttle response also I found myself shifting for 6th gear all the time now when before hardly ever. the exhaust worked out really well also I bought a set of brand new take off CVO mufflers on E Bay and had the PR guys install Fullsac 2 ins cores that combined with the 2 into 1 into two pipe was just right not too loud but has some snort when you get on it. Have to say thanks to the guys at PR the tuning was spot on no stumbles or hesitations and no de accel pop. this should tide me over for a few months until I can swing a 107 set up. Reminder I am at 5000ft above sea level.
Bob
Bob
Thread
Thread Starter
Forum
Replies
Last Post
ccrogue
Ignition/Tuner/ECM/Fuel Injection
5
May 6, 2015 08:39 PM
