!!!! My V&H Big Radius 2-2 came in today!!!
Thread Starter
|
Road Master
Joined: Dec 2006
Posts: 795
Likes: 9
From: Manasquan NJ
!!!! My V&H Big Radius 2-2 came in today!!!
After looking at all the pics on line from everyone on this site, I can't wait to get these on my Springer! Does anyone know what it cost to get these pipes and an SERT installed?
Intermediate
Joined: Apr 2007
Posts: 31
Likes: 0
From:
RE: !!!! My V&H Big Radius 2-2 came in today!!!
My bill was $ 565 for the pipes, $ 415 for the SERT , $ 170 of labor to install both, and $ 255 of dyno time for a total of $1405 (pre-tax). Pic below (I hope...)
Intermediate
Joined: Apr 2007
Posts: 31
Likes: 0
From:
RE: !!!! My V&H Big Radius 2-2 came in today!!!
I decreased and re-sized some pics, clicked the "click here to upload" and selected the "embed picture in post" selector and it's not coming up. I'm technically challenged by this forum :-)
Anyway, if you want to mail me your personally e-mail addy, I'd be happy to send to you.
And to answer yourquestion, my HP went from 80 to 96 and my ft. lb. torque to the rear wheel went from 96 to 114.
Anyway, if you want to mail me your personally e-mail addy, I'd be happy to send to you.
And to answer yourquestion, my HP went from 80 to 96 and my ft. lb. torque to the rear wheel went from 96 to 114.
Thread
Thread Starter
Forum
Replies
Last Post
ramrod311
Dyna Glide Models
11
Jun 16, 2010 12:10 PM
