No power/electrical---23 heritage
Thread Starter
|
Cruiser
Joined: Mar 2023
Posts: 216
Likes: 77
From: Michigan
No power/electrical---23 heritage
I was getting the bike cleaned up and ready to ride, but before hand I swapped my front signals. I went to re learn the bcm for less, and my dumbass didn't have it on the tender. Well battery got drained, but no problem, I wired in a pigtail for my biostpack when I put in my lithium battery last year. I plug it in turn it on, and no juice when turning on the ignition. I have a little voltage dongle for the tender pigtail so I can check it so often, even that isn'tgetting juice. I checked the main fuse, and the 3 smaller fuses, 2x 7.5a and a 5a. All four are good and clean. I'm at a loss here. I have the boost pack still plugged it and switched on, been sitting four about 10mins and nothing, but it at least should've switched on the electrical, even if it won't turn over. I didn't even try to start it. Any ideas what else to check? Or should I get I to a shop. I'm so pissed right now, perfect evening for a ride. The bike is a 23 heritage, not even 5k in the clock, never had any issues until I drained the **** running the four ways with a cold battery.
Thread Starter
|
Cruiser
Joined: Mar 2023
Posts: 216
Likes: 77
From: Michigan
How do I delete posts? I want this stricken from the record. My dumbass only have the boost pack switched on, I wasn't running no power output. Plus side, fired right up like it ain't been sitting since November lol
Thread
Thread Starter
Forum
Replies
Last Post
smokyheritage
Softail Models
6
Aug 18, 2016 10:33 PM
hdpig
Ignition/Tuner/ECM/Fuel Injection
2
Dec 27, 2006 12:21 AM
