say'n hey
Thread Starter
|
5th Gear
Joined: Sep 2017
Posts: 9
Likes: 1
From: Oklahoma
say'n hey
This is tweaked02, and I've been looking over the forum for a few years. Thought it might be a good time to become a member since I'm doing a 110 bolt-on in the near future. I already have most of what's needed, but still take into consideration others expertise.
1st question, does anyone know anything good or bad about Hammer Performance heads? The Smash treatment is the set I plan on using; 1.9" intake valve, 1.615" exhaust valve, 1.740" intake port runners, 85cc combustion chambers, 600 lift B-hives. Any info appreciated.
My Bike: 103ci 2002 FLSTCI, Jims 4&3/8" flywheel, SE stroker forged pistons, ported heads W/1.9" intake valve, HPI 56mm throttle body (from 2006), Andrews 57n cam, and all the other good stuff.
1st question, does anyone know anything good or bad about Hammer Performance heads? The Smash treatment is the set I plan on using; 1.9" intake valve, 1.615" exhaust valve, 1.740" intake port runners, 85cc combustion chambers, 600 lift B-hives. Any info appreciated.
My Bike: 103ci 2002 FLSTCI, Jims 4&3/8" flywheel, SE stroker forged pistons, ported heads W/1.9" intake valve, HPI 56mm throttle body (from 2006), Andrews 57n cam, and all the other good stuff.
Last edited by tweaked02; Sep 10, 2017 at 01:10 AM.
Thread
Thread Starter
Forum
Replies
Last Post
tweaked02
General Harley Davidson Chat
4
Sep 12, 2017 05:00 AM
