Alarm Question and Possible Problem(Update)
Thread Starter
|
Road Captain
Joined: May 2007
Posts: 546
Likes: 2
From: Rio Grande Valley, TX
Alarm Question and Possible Problem(Update)
(I have an 97 Custom and had a siren and pager installed today. The dealer just handed me the key fob and sent me on my way with no instruction on how to use the alarm and pager. So when I got home I pulled the instructions out of the packet and read them. Ok, simple enough to turn it on and off. I set the alarm, the siren chirps a couple times and the pager vibrates with all the cute little flashing lights. I bump the bike - nothing. I bump it harder - nothing. I lift the bike off the stand and straighen it out - nothing. Am I missing something? Is there anything else I need. I figured since the 07s come with a built-in security system all I needed was the siren and pager. When I move the bike the lights don't flash either anymore.
Update: Ok, I'm stupid. I had the fob on my belt - duh.[:@]
Update: Ok, I'm stupid. I had the fob on my belt - duh.[:@]
Outstanding HDF Member
Joined: Mar 2007
Posts: 3,184
Likes: 5
From: Oregon
RE: Alarm Question and Possible Problem(Update)
did you have the fob next to the bike..or like in 100 or so feet..
hmm put the pagers and fob in your back yard then go bring the bike to the street.. it should go off..
then go run n get ur fob to turn the sucker off
hmm put the pagers and fob in your back yard then go bring the bike to the street.. it should go off..
then go run n get ur fob to turn the sucker off
Thread
Thread Starter
Forum
Replies
Last Post
