2013 Heritage LED signals
Thread Starter
|
Stage II
Joined: Mar 2021
Posts: 2
Likes: 0
From: Florida
2013 Heritage LED signals
My wife bought a 2013 FLSTC and wants to upgrade her signals to LED. We installed the lights and a Badlands load equalizer and the lights are still giving the rapid flash error. What am I doing wrong?
Advanced
Joined: Feb 2021
Posts: 52
Likes: 23
From: Illinois
If you are talk about the 6 quick flashes you get when you first turn the ignition on that is typical for older bikes with leds. My dealer said it is difficult to fool the bikes complete programing but your turn signals themselves should not hyper flash when you use them.
Thread Starter
|
Stage II
Joined: Mar 2021
Posts: 2
Likes: 0
From: Florida
Thanks for replying. The front signals appear to flash at the correct rate however when I installed the rear signals they flash once and then nothing. They wont even flash again if I turn the signal to off then on. I've gone through the reprogramming steps and the problem persists.
Advanced
Joined: Feb 2021
Posts: 52
Likes: 23
From: Illinois
Thanks for replying. The front signals appear to flash at the correct rate however when I installed the rear signals they flash once and then nothing. They wont even flash again if I turn the signal to off then on. I've gone through the reprogramming steps and the problem persists.
Thread
Thread Starter
Forum
Replies
Last Post
sdeck86
Ignition/Tuner/ECM/Fuel Injection
3
Feb 22, 2015 04:53 AM
