almost there!
Thread Starter
|
Road Master
Joined: Sep 2007
Posts: 812
Likes: 4
From:
[QUOTE=scooter34;4812905]How well is that BDL holding up for you and was the install difficult?[/QUOTE
so far so good, but ive only rode prolly 30 miles. as far as the install its stright forward and pretty easy, the only hard part was pulling the race for the inner primmary bearing. there's a special tool for it, that cost 213. luckily i found a local mech, that done it for 15. i did have to go buy some longer bolts for the motor plate as the ones sent with it were too short.
so far so good, but ive only rode prolly 30 miles. as far as the install its stright forward and pretty easy, the only hard part was pulling the race for the inner primmary bearing. there's a special tool for it, that cost 213. luckily i found a local mech, that done it for 15. i did have to go buy some longer bolts for the motor plate as the ones sent with it were too short.
Thread
Thread Starter
Forum
Replies
Last Post
