2005 Fatboy with PC5
#1
2005 Fatboy with PC5
I bought a Power Commander 5 from Fuel Moto as part of a stage 1 upgrade. It has been hooked up to my bike for about a year and this weekend was the first time I started the bike while it was hooked to my laptop and noticed that it is not receiving some information about the bike like engine temperature.
It was a good exercise though because I had to reset the throttle as it was reading 4% when it was idling.
Anyone know why the engine temperature would not show?
It was a good exercise though because I had to reset the throttle as it was reading 4% when it was idling.
Anyone know why the engine temperature would not show?
#2
First...i thought the 2005's run off a PCIII, not a PCV..
Second..have you tried updating your Powercommander's firmware from their site?
http://www.powercommander.com/powerc...x?ProdType=PCV
Second..have you tried updating your Powercommander's firmware from their site?
http://www.powercommander.com/powerc...x?ProdType=PCV
#5
I bought a Power Commander 5 from Fuel Moto as part of a stage 1 upgrade. It has been hooked up to my bike for about a year and this weekend was the first time I started the bike while it was hooked to my laptop and noticed that it is not receiving some information about the bike like engine temperature.
It was a good exercise though because I had to reset the throttle as it was reading 4% when it was idling.
Anyone know why the engine temperature would not show?
It was a good exercise though because I had to reset the throttle as it was reading 4% when it was idling.
Anyone know why the engine temperature would not show?
If I were you, I'd be calling him up to answer any questions. That's the way my evil mind works.
Last edited by Weevil; 02-18-2013 at 08:04 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Mike Horrell
General Harley Davidson Chat
55
10-19-2009 01:48 AM