Recommendations for Sheetmetal, Fender work
Thread Starter
|
Road Captain
Joined: Oct 2012
Posts: 695
Likes: 50
From: South Carolina
Recommendations for Sheetmetal, Fender work
I am having to swallow the fact that a local "builder" is going to take me to the cleaners for fender work. Purchased a Klockwerks fender and was told they could stretch it to make it look like a hugger type fender. They keep racking up labor hours on my bill while they hack away trying to make it look right. So I am pulling the plug next week on the Frankenstein project they have done on my bike.
I am looking for recommendations, first hand experience, of somebody I could send the fender to; to see if it can be salvaged. I am not asking the impossible. Just a stretched, hugger type rear fender. Any help is appreciated.
I am looking for recommendations, first hand experience, of somebody I could send the fender to; to see if it can be salvaged. I am not asking the impossible. Just a stretched, hugger type rear fender. Any help is appreciated.
Road Captain
Joined: Oct 2013
Posts: 503
Likes: 47
From: nj
Thread
Thread Starter
Forum
Replies
Last Post
CLL375
Good Or Bad Shopping Experiences At HDF
0
Jun 3, 2014 03:54 PM
