I you have time I would really appreciate some close up pics of your setup !!

 

I don't think the stock wires will work if you run them internally. Way to much bends going through the bars. You will need longer cables.
My cables are all ran external and in the stock location other than I moved them above the front tank mount.
I will see if I have any close up pictures. If not I will snap some in a few and post them up!

 

here are some close ups!
Brake line I ran through a little clamp mounted under the lower tree.

left side of tank, Cables ran above the front tank mount

right side of tank I ran the cables above the ignition switch. Zip tied them together.

zip tied the brake cable and throttle cables together.

the larger black cables that are in the sleaves for the control switches, I zip tied them to the upper fork bolts in the upper tree.

 

Thanks a lot ! Very much appreciated !!!

 

no problem, glad to help out!

 

After looking afte setup again an wanting to run the wires internally I think imma go with the 12 inch burly kit and use the wires and brake line and maybe clutch and just keep the throttle cables cu I k ow I'll need them at some point for something haha