10" Holey Roller handlebars

Reply Subscribe

Thread Tools

Search this Thread

Mar 24, 2014 | 10:48 AM

#11

cable guy

Cruiser

Joined: Nov 2012

Posts: 166

Likes: 0

From: goodyear

If you are going to internal wire them then you will need the 12 inch kit,if you run them out side like I did the stock wire will all work just find.There is some slack under the tank that you can pull loose.

Mar 24, 2014 | 01:10 PM

#12

Spookymason

Advanced

Joined: Jul 2013

Posts: 52

Likes: 0

From: Neath UK

Quote:

Originally Posted by cable guy

Thanks cable guy I am going to run them internally as the bars have caps to make it easier (I hope ) so I will get the 12" kit as you said. Thanks again.

Apr 6, 2014 | 02:55 PM

#13

fabiomontoyac

Stage III

Joined: Aug 2013

Posts: 3

Likes: 0

From: florida

break line for r6c 8" bars

Quote:

Originally Posted by Sweforty8

Yep you gotta replace the bake line. A 43"-45" line will do it. Go for a 60 degree lower banjo (caliper) and a 30 or 60 upper.

Can anyone tell me where to buy only the extended break line to instal R6C 8" handlebars for sporter 883?
tks...

Apr 6, 2014 | 04:23 PM

#14

Sammy b

Novice

Joined: Nov 2013

Posts: 20

Likes: 1

From: Rochester, NY

Quote:

Originally Posted by Spookymason

I've just ordered 10" r6c Frisco bars for my 2011 iron not looking forward to the install either but I just hope I can use the std cables and get a new break line and wires. That's what I've seen folks do on here. Does anyone know what length wiring kit I would need with no tank lift.

Here is the brake line i used when installing 8" Chumps on my 48, $63 with free shipping, 44", four crush washers included ... Good Luck