Slip on alignment
Thread Starter
|
2nd Gear
Joined: Jan 2018
Posts: 6
Likes: 0
From: The North
Slip on alignment
I have installed a pair of RCX slip-ons onto my 2017 RKS. The right slide aligns perfectly with plenty of space under the bag....but, the left side seems to be higher and closer to the bag. Why...what did I do wrong...what wasn't is the instructions to prevent this?
Elite HDF Member
Joined: May 2007
Posts: 4,452
Likes: 798
From: Bear Flag, lower end
Why did you post this in the "Touring forum" and the "Sportster forum"?
Elite HDF Member
Joined: May 2007
Posts: 4,452
Likes: 798
From: Bear Flag, lower end
Seasoned HDF Member
Joined: Feb 2009
Posts: 5,642
Likes: 1,985
From: Cleveland Zoo
I don't think you did anything wrong, I've heard of this happening, even stock mufflers are not perfect. I would try loosening the clamps and mounts for that side, re-align and tighten.
Elite HDF Member
Joined: May 2007
Posts: 4,452
Likes: 798
From: Bear Flag, lower end
should do the trick for you.
Trending Topics
Thread Starter
|
2nd Gear
Joined: Jan 2018
Posts: 6
Likes: 0
From: The North
now that was an insightful reply!
I'm sure once you figure that out, I will have already obtained actual suggestions to resolve my issue....kinda like what "OldMike" provided which was in fact helpful.
I'm sure once you figure that out, I will have already obtained actual suggestions to resolve my issue....kinda like what "OldMike" provided which was in fact helpful.
HD Forum Stories
The Best of Harley-Davidson for Lifelong Riders
Jason Momoa Is Turning Classic Harleys Into PHEVs
Verdad Gallardo
Harley-Davidson Fat Boy Becomes a Dark, Decepticon-Inspired Custom
Verdad Gallardo
6 Weirdest Harley-Davidsons Ever Sold to the Public
Verdad Gallardo
7 Times Harley-Davidson Chucked Tradition Out the Window
Verdad Gallardo
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Verdad Gallardo
8 Best Harley-Davidson Motorcycles Ever
Pouria Savadkouei
10 Worst Harley-Davidson Motorcycles Ever
Pouria Savadkouei
Killer Custom's Jail Break Is The Breakout That Refused to Blend In
Verdad Gallardo
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Verdad Gallardo
Grand HDF Member
Joined: Jan 2012
Posts: 4,464
Likes: 2,921
From: Oklahoma
If you haven't fiddled with mufflers much before it is easy to install them slightly twisted, that is the rear mounting lugs are not at the 12 o'clock position but might be at 11 to 11:30, for example. That will both raise the muffler slightly and move it a bit to the left or right. If it were a saddle bag support problem, you should have noticed it when removing the old mufflers. Are the mounting lugs on both mufflers the same height? I can hardly believe a factory could mess that up, but anything is possible. Any chance one of the lengthwise flat mounting bars that go between the lugs and through the rubber cushion is upside down? That would be hard to force through the rubber cushion but if you didn't notice the difference, the cushion is rubber an can be overcome. Hope it is something easy and does not require bending or realigning something else.