fueling problems
Thread Starter
|
4th Gear
Joined: Apr 2021
Posts: 8
Likes: 1
From: AMERICA
fueling problems
i have a 2000 flhtcui with a Marelli set up yes i know get rid of it now that that is said the bike died on me i shot gas in the throat and it fired right up ran for a while and died i replaced the fuel pump code said crank sensor so put a new one in,still same problem i just ordered a engine temp sensor and fuel pressure regulator,putting new cam sensor in tomorrow any other idea's out there oh i forgot to say it will start up and idle for a while then just dies squirt gas in throat and will fire,no new codes,question ,,if cam sensor is going bad will it shut injectors off?
Last edited by wiileep; Apr 17, 2021 at 09:24 PM.
Road Master
Joined: Jan 2020
Posts: 856
Likes: 373
From: Duke City, NM
You had a code for bad crank position sensor and replaced it? I’ll bet it it the other side. The sensor was replaced but it plugs into another wire. I’ll guess that is where the issue probably is. Might want to check the relays under the seat if I’m wrong.
Road Master
Joined: Jan 2020
Posts: 856
Likes: 373
From: Duke City, NM
I thought the 2000 had a plug in to a wire that then had a little overlap screw collar to secure. I think there are relays under the seat also that are fuel injection.
I’m glad you have an idea where to look. Loose wires have always driven me nuts which is probably why I was looking there.
I’m glad you have an idea where to look. Loose wires have always driven me nuts which is probably why I was looking there.
Thread Starter
|
4th Gear
Joined: Apr 2021
Posts: 8
Likes: 1
From: AMERICA
i wish it just plugged lol had to un pin it pull it thru the harness put the pins back in and plug it back in will have to do the same with cam sensor's,next week the fuel regulator will get here it not in the tank like the 03 and engine temp sensor i figured its 21 years old might as well put it in new also
Thread
Thread Starter
Forum
Replies
Last Post
slowhand
Ignition/Tuner/ECM/Fuel Injection
1
Nov 4, 2009 08:14 PM
