Another Garmin installed
I used a two pole flat connector in-line so I could take the cradle off easily and used 1/8" split loom to make it nice
[IMG]local://upfiles/13641/99008642F50F49A995A08313415FF72F.jpg[/IMG]
I tied the power into the unused spade plugs attached to the headlamp wire harness
[IMG]local://upfiles/13641/14A3AD8130DC400C93181C286CB7D756.jpg[/IMG]
I tied up the excess wire in a loop and ziptied it above the back of the cig lighter and attached to a bracket
[IMG]local://upfiles/13641/06D10380ABAF426297855AE7153B48DA.jpg[/IMG]
Viola! Complete with 105th splash screen.
[IMG]local://upfiles/13641/82C35098F526416596BC9834C3A43545.jpg[/IMG]
[IMG]local://upfiles/13641/99008642F50F49A995A08313415FF72F.jpg[/IMG]
I tied the power into the unused spade plugs attached to the headlamp wire harness
[IMG]local://upfiles/13641/14A3AD8130DC400C93181C286CB7D756.jpg[/IMG]
I tied up the excess wire in a loop and ziptied it above the back of the cig lighter and attached to a bracket
[IMG]local://upfiles/13641/06D10380ABAF426297855AE7153B48DA.jpg[/IMG]
Viola! Complete with 105th splash screen.
[IMG]local://upfiles/13641/82C35098F526416596BC9834C3A43545.jpg[/IMG]
Trending Topics
ORIGINAL: Wecroft
Looks great. Just make sure the bare post on the connector that's left on the bike is the Negative terminal.
Looks great. Just make sure the bare post on the connector that's left on the bike is the Negative terminal.
Thread
Thread Starter
Forum
Replies
Last Post










