need answer on running turn signal

Reply Subscribe

Thread Tools

Search this Thread

Sep 12, 2010 | 08:22 PM

bklyn roadking

Thread Starter

Road Captain

Joined: Nov 2009

Posts: 664

Likes: 3

From: bklyn ny/dingmans ferry pa

need answer on running turn signal

i noticed that when i hit the brakes the rear tail light and rear turn signal go on which is great but when i release the brake the go out the turn signal dont stay on as park lights what would i have to do to have them as running light also.besides just brake lights

Sep 12, 2010 | 08:28 PM

jimsuver

Supporter

Joined: Sep 2007

Posts: 433

Likes: 5

From: Columbus, Indiana

That is the way I would want them. If your bike is 07 or newer a run=brake-turn plug will get you what you want I think. About 50.00

Sep 12, 2010 | 08:28 PM

dawg

Seasoned HDF Member

Joined: Jun 2006

Posts: 28,552

Likes: 3,954

From: Vermont

It's called a run/turn/brake module. You probably have just a turn/brake module

Sep 12, 2010 | 08:38 PM

soos

Grand HDF Member

Joined: Sep 2005

Posts: 4,890

Likes: 73

From: MA

I will take it that you have the HD module that converts the directionals to brake lights only. I will assume also that you do have red lenses on your directionals. That module was discontinued back in '06 and replaced with HD # 69461-06 (at least to fit my '06 FLHTCI) which went to the running/brake function. IMO, you are much better off with the setup that you have now because the difference in light intensity from the running mode to brake mode is barely noticable. I had both setups and went back to the brake only mode. I felt that the directionals going from off to brake was a better attention getter than going from running to a just barely brighter/brake mode.

Last edited by soos; Sep 12, 2010 at 08:42 PM.