Anybody Know how to Remove the Insides From Front Turn Signals?
Thread Starter
|
Advanced
Joined: Mar 2010
Posts: 54
Likes: 0
Anybody Know how to Remove the Insides From Front Turn Signals?
I just bought HD passing lamps and a front turn signal kit for a 2010 Street Glide. Would like to have them powder coated Matte Black, but can't figure out how to remove the reflector and socket from the turn signals. I've seen others powder coated so there must be a way. Anybody know how?
Thanks,
Eric
Thanks,
Eric
Road Master
Joined: Mar 2005
Posts: 818
Likes: 0
From: Jersey Shore
Its held in with a rubber grommet. Take a tiny screw driver and gently push in the wires from the outside. Then work at pulling the reflector out. I used and old 90 degree angle pick and stuck it down by the bulb contact poits and work the reflector out. Probably an allen wrench may work too....
Thread
Thread Starter
Forum
Replies
Last Post
