Lim Mode or ??
Thread Starter
|
Road Warrior
Joined: Apr 2007
Posts: 1,406
Likes: 5
From: Sunnyvale, Ca.
Lim Mode or ??
I Read, these 3 Forum threads
Link to the codes if it helps you;
https://www.hdforums.com/forum/electr...tic-codes.html
https://www.hdforums.com/forum/touri...511-p2101.html
https://www.hdforums.com/forum/touri...-update-2.html
My bike is going into Limp Mode - but throwing No Codes - spent my Saturday cleaning and Dieltric Greasesing every connection...
I got it out of Limp Mode when I re set ECM using the 3 - 10second on/off - ign switch procedure.
What else should I look for ?
Link to the codes if it helps you;
https://www.hdforums.com/forum/electr...tic-codes.html
https://www.hdforums.com/forum/touri...511-p2101.html
https://www.hdforums.com/forum/touri...-update-2.html
My bike is going into Limp Mode - but throwing No Codes - spent my Saturday cleaning and Dieltric Greasesing every connection...
I got it out of Limp Mode when I re set ECM using the 3 - 10second on/off - ign switch procedure.
What else should I look for ?
Novice
Joined: May 2008
Posts: 18
Likes: 0
From: SE MICHIGAN
Had same problem with mine (2008 Ultra) in Sturgis and had to be towed to Rapid City, they replaced terminals behind air filter from zinc terminals to silver and have had no problems since. Not sure if this affects the 2009's
Pat
Pat
Thread Starter
|
Road Warrior
Joined: Apr 2007
Posts: 1,406
Likes: 5
From: Sunnyvale, Ca.
I'll check - wonder if the replaced entire wire harness ? or ?
Thread
Thread Starter
Forum
Replies
Last Post
Inspector 12
Ignition/Tuner/ECM/Fuel Injection
8
Jul 16, 2013 06:54 AM
