DrTiki's Winter Project(s)
Thread Starter
|
Stellar HDF Member
Joined: Apr 2007
Posts: 2,347
Likes: 602
From: The 9th Island
DrTiki's Winter Project(s)
I rather be riding my bike than working on it so I have had some lil odds-n-ends stuff that I wanted to take care of but never got to it.
So this weekend I am on-call for work and I basically can't leave the house so I figured this would be a good time to try and take care of it.
I bought a small lil cigar smoking Tiki recently but never could figure out where to put it. Noticed it was about the same size as my GPS cover...
Tiki on top of the cover
Sanded down the inside so that it would fit the cover better.
Overlaps the edges now and lays flat on the cover.
JB Welded the two together (I use this stuff like Duct Tape) and let it sit over night and this morning...
So there ya go... my big winter project.
So this weekend I am on-call for work and I basically can't leave the house so I figured this would be a good time to try and take care of it.
I bought a small lil cigar smoking Tiki recently but never could figure out where to put it. Noticed it was about the same size as my GPS cover...
Tiki on top of the cover
Sanded down the inside so that it would fit the cover better.
Overlaps the edges now and lays flat on the cover.
JB Welded the two together (I use this stuff like Duct Tape) and let it sit over night and this morning...
So there ya go... my big winter project.
Thread Starter
|
Stellar HDF Member
Joined: Apr 2007
Posts: 2,347
Likes: 602
From: The 9th Island
Project #2:
After a year or so I finally got around to installing a relay to my ACC switch so that I could flip between my maps on my PC-V.
Soldered a pigtail adapter to a relay socket and cleaned up the remaining wires.
Wrapped it up in electrical tape after soldering on the leads to the PC-V and tucked it in next to the ECM.
Overall shot showing how everything sits under my seat.
After a year or so I finally got around to installing a relay to my ACC switch so that I could flip between my maps on my PC-V.
Soldered a pigtail adapter to a relay socket and cleaned up the remaining wires.
Wrapped it up in electrical tape after soldering on the leads to the PC-V and tucked it in next to the ECM.
Overall shot showing how everything sits under my seat.
Thread
Thread Starter
Forum
Replies
Last Post
