Air Cleaner Swap/ Re-map Tuner?
Thread Starter
|
5th Gear
Joined: Apr 2011
Posts: 9
Likes: 0
From: Long Island New York
Air Cleaner Swap/ Re-map Tuner?
I have a 2011 FLTRU with a S/E ventilator air cleaner, S/E slipons and S/E 255 cams. The bike runs flawlessly. However, the A/C is a real bleeder. If I were to install an aftermarket A/C would I have to have my S/E Super Tuner,32109-08B, re-mapped?. I was leaning towards an S&S Stealth A/C or a Boyesen Power-X A/C. Any thoughts? Thanks in advance.
Road Master
Joined: Sep 2010
Posts: 803
Likes: 1
From: Port St. Lucie FL
+1. As long as your going from a high flow a/c to another high flow you should be ok. I went from an AN Big Sucker to the SE filter for the same reason, was fine.
Thread Starter
|
5th Gear
Joined: Apr 2011
Posts: 9
Likes: 0
From: Long Island New York
The S/E Ventilator A/C on my bike spews oil like non other I have had. I had the same A/C on a 2006 FLHTCUI with a stage2 95" kit. I also installed a Doherty Mystfree Breather in each rocker box on the older bike only. Both bikes ran/run Syn3 oil. The 2006 did not drip any oil from the A/C. I figured the Ventilator A/C would work fine even without the aftermarket breathers.
In this case it does not.
In this case it does not.
Thread
Thread Starter
Forum
Replies
Last Post
fogrider
Tri Glide, RG3 & Freewheeler Models
5
Jun 23, 2011 08:46 PM
