O2 sensor bung placement
Thread Starter
|
Cruiser
Joined: Nov 2006
Posts: 215
Likes: 0
From: N.W. Iowa
O2 sensor bung placement
I'm looking at the Thundermax tuner, I got a '06 Street Glide with Rineharts on it, but there are no O2 bungs on them. There appears to be one on the right side behind the foot board with a plug in it, but not one on the left.
Does the Thundermax only work with sensors? I was looking at my stock exhaust and I did not see any bungs on them either.(I could of missed them)If I do need the bungs where is the best place to have them welded in?
Does the Thundermax only work with sensors? I was looking at my stock exhaust and I did not see any bungs on them either.(I could of missed them)If I do need the bungs where is the best place to have them welded in?
Banned
Joined: Mar 2006
Posts: 8,603
Likes: 10
RE: O2 sensor bung placement
DTT says 2-8" from the head...yep, you gotta have em welded in...take into consideration the sensor and lead wire need abit of room as well...TMAX should be very close to the DTT requirements
Thread
Thread Starter
Forum
Replies
Last Post
