Timing of this engine is a #$%#@$ pain.

In an effort to time the ignition of the motor, I remove the spark plugs and use the starter to turn the motor over.

This prevents alot of oil from blowing out the timing hole.(as I cant see anything thru the plastic timing hole tool)

When I check the advance mode I put a vacuum onto the VOES to make contact with ground.

Right now whether I have the vacuum on or not, the ignition timing is on the dot of the flywheel (35 degrees advanced, not the line for TDC)

It apears that my ignition system is locked in the full advance mode.

Is this at all possible that the ignition module is stuck in the full advanced mode?

 

You might get some tech help in that section.

 

Thanks for the advice...I'm having difficulty today...it's an old guy thing

 

Welcome Firsthd. Go to the tec section, get better results than here.
https://www.hdforums.com/forum/gener...ech-forums-58/
See ya in the main forum.
Snarly

 

Welcome to the forum from southeastern Michigan, U.S.A.

 

Welcome aboard from New York.

 

Thank you all, it's nice to have a p[lace where we can all talk about our scooters....hehe

Thabnks again... I got this post thing workin and put this post on the tech site...

 

wellcome from England.

 

Welcome to the forum Firsthd, enjoy your stay.
.
.
.
.

 

Howdy, welcome to the forum, hope you enjoy your experience here.

.
.
.
.