OEM heat grip question
Thread Starter
|
Cruiser
Joined: Dec 2017
Posts: 107
Likes: 11
From: Northern Illinois
OEM heat grip question
Going to install the basic black heated grips on '15 ultra classic and every video I have seen show the powered connection already in the fairing, the instructions say I need P/N 69200722. So is this kit need or not?
Stellar HDF Member
Joined: Jun 2017
Posts: 2,328
Likes: 1,163
From: Oklahoma
Shouldn’t need it, the power connector (2 wires) will be inside the fairing on the clutch side of center, coming off the back of the lighter/power port and the inter-connect connector (the 2 wires that connect the throttle side grip to the clutch side grip) will be on the throttle side of center, just inside the fairing. Look for it in the area where the wires from the right switchpack comes thru the fairing.
I’ve got the only Rushmore fairing bike that requires that extra harness/adapter kit, I think, which is a RGU
I’ve got the only Rushmore fairing bike that requires that extra harness/adapter kit, I think, which is a RGU
Last edited by Ssitruc; May 19, 2021 at 09:43 PM.
Thread
Thread Starter
Forum
Replies
Last Post
p51bombay
2014-2024 Touring Models
48
Nov 26, 2015 08:05 AM
