O2 Wire Question
Thread Starter
|
Tourer
Joined: Jul 2008
Posts: 251
Likes: 0
From: Muscatine, IA
O2 Wire Question
I'll try to make this short. 2015 Limited with V&H Dresser Duals & Hi-Output mufflers and stage 1 air cleaner. Dealer did a dyno with SESTP and still didn't sound quite right. One side sounded good and the other one sputtered...a lot. Called them and they said to bring it back and they would run another dyno and check it. Picked it up and they said it had a bad O2 wire and that was the reason for the bad tune. While riding home, it sounded a lot better. Not 100% but close. Now after a few hundred miles it's starting to revert back to the way it sounded before. Is there something that could cause the wire and/or sensor to go bad again? I do engine brake a bit when I downshift but nothing too crazy. I wouldn't think it would cause some sort of false reading for the O2 sensors but I don't know. About ready to switch to the power duals so I get an "even" sound from both sides :/
Thread Starter
|
Tourer
Joined: Jul 2008
Posts: 251
Likes: 0
From: Muscatine, IA
Thread
Thread Starter
Forum
Replies
Last Post
