Help!!!
Thread Starter
|
Road Master
Joined: Jan 2012
Posts: 895
Likes: 306
From: se wi
Help!!!
Finally got around to installing new handlebars. Ran all new wires and got the bars in place. Checked to make sure all the switches worked and everything was good. Went to put on the front brake lever and then the alarm stared screaming. Went to disconnect the batter and as I was taking the seat of the alarm stopped. Now I have nothing, no power, no security light flashing on the dash. I checked the main fuse, disconnected the battery and reconnected it and nothing. Took the switches back apart and there are no pinch wires. I have no idea what to do now. Is there anyone that can help? Its a 16 cvo sg.
Road Warrior
Joined: Jul 2015
Posts: 1,440
Likes: 185
From: Fond du Lac WI
Are all connectors seated properly in fairing?
Last edited by FrenchieM; May 15, 2021 at 08:15 PM. Reason: Spelling
Thread Starter
|
Road Master
Joined: Jan 2012
Posts: 895
Likes: 306
From: se wi
Took it all apart today and found I didn’t seat the wires in the switch housing properly. Ended up pinching a wire that grounded out on the bars and took out the 5 amp battery fuse. Got it all back together and went for a short ride. Hope everything will be good now.
Thread
Thread Starter
Forum
Replies
Last Post
Tat2u
Dyna Glide Models
9
Apr 25, 2009 07:49 PM
