2018 RGS 4 speaker vs 8 speaker setup?
Thread Starter
|
Intermediate
Joined: Jun 2011
Posts: 34
Likes: 1
From: Northern VA
2018 RGS 4 speaker vs 8 speaker setup?
Good Morning All,
I have been acquiring parts for my stereo install and have a few left over from a previous stereo or two.
My current install will look like the following:
1) Stock RGS Headunit
2) BT355 Front/Rear
3) Cerwin Vega B52 Amp Running Euporia EPC6K's with tweeter in hogtune grilles
4) Diamond Micro 4 bridged running WDX69Moto's in Hogtunes Lids
5) I already have the V-twin audio wires/harness for input to stereo and output to speakers as well
I have a friend with an extra Moto 600.4 and I have an extra set of DD VO 6.5's for the fairing lowers and I also have a set of Memphis Mojo 8's for the bags. So I was thinking 600.4 to the 6.5's each on their own channel, B52 to the 6x9's and Micro 4 to the 8's.
My questions are:
1) Can I run this 8 channel set up through the Rockford DSR or would I need to run RCA splitters?
2) If I run the DSR do I still need the BT355's?
3) Will the 600.4 and the two micro amps all fit in the fairing?
Normally I would tear it apart and just work on it as I go along, however due to loss of my garage I am using a friends and don't want to keep it longer than necessary.
Any help is appreciated.
I have been acquiring parts for my stereo install and have a few left over from a previous stereo or two.
My current install will look like the following:
1) Stock RGS Headunit
2) BT355 Front/Rear
3) Cerwin Vega B52 Amp Running Euporia EPC6K's with tweeter in hogtune grilles
4) Diamond Micro 4 bridged running WDX69Moto's in Hogtunes Lids
5) I already have the V-twin audio wires/harness for input to stereo and output to speakers as well
I have a friend with an extra Moto 600.4 and I have an extra set of DD VO 6.5's for the fairing lowers and I also have a set of Memphis Mojo 8's for the bags. So I was thinking 600.4 to the 6.5's each on their own channel, B52 to the 6x9's and Micro 4 to the 8's.
My questions are:
1) Can I run this 8 channel set up through the Rockford DSR or would I need to run RCA splitters?
2) If I run the DSR do I still need the BT355's?
3) Will the 600.4 and the two micro amps all fit in the fairing?
Normally I would tear it apart and just work on it as I go along, however due to loss of my garage I am using a friends and don't want to keep it longer than necessary.
Any help is appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
