Where did you mount the RF DRS1 on your Street Glide?

Reply Subscribe

Thread Tools

Search this Thread

Feb 19, 2019 | 06:47 PM

HWill

Thread Starter

Cruiser

Joined: Sep 2012

Posts: 107

Likes: 0

From: Buckeye, AZ

Where did you mount the RF DRS1 on your Street Glide?

Looking for pictures or advice on where to mount the Rockford Fosgate DRS1 on my 2018 Street Glide Special. Will be installing the same time with RF front and bag kits.

Thanks

Herb

Feb 19, 2019 | 07:02 PM

Babyboy

Stellar HDF Member

Joined: Aug 2014

Posts: 2,841

Likes: 572

From: Lockport Illinois

Quote:

Originally Posted by HWill

Looking for pictures or advice on where to mount the Rockford Fosgate DRS1 on my 2018 Street Glide Special. Will be installing the same time with RF front and bag kits.

Thanks

Herb

Will you be using the stock speaker pods or the Biketronics brackets that replace the pods?

Feb 19, 2019 | 07:06 PM

HWill

Thread Starter

Cruiser

Joined: Sep 2012

Posts: 107

Likes: 0

From: Buckeye, AZ

Quote:

Originally Posted by Babyboy

Will you be using the stock speaker pods or the Biketronics brackets that replace the pods?

Will be using the stock speaker pods.

Feb 19, 2019 | 07:18 PM

Babyboy

Stellar HDF Member

Joined: Aug 2014

Posts: 2,841

Likes: 572

From: Lockport Illinois

You may be able to mount the amp all the way back against the guages and put the DSP in front of the amp toward the headlight or behind the headlight under the headunit.
I dont believe it will fit in the cubby on the clutch side were the CB module goes

Feb 26, 2019 | 08:10 PM

HWill

Thread Starter

Cruiser

Joined: Sep 2012

Posts: 107

Likes: 0

From: Buckeye, AZ

Quote:

Originally Posted by Babyboy

I have the RF amp installed and yeah there is no room where the CB module goes. I'm looking at mocking something up tomorrow that will put the DRS1 in front of the amp or down below it.

Herb

Feb 27, 2019 | 09:58 AM

FLYINGBROKE

Road Captain

Joined: Jun 2014

Posts: 574

Likes: 34

From: Idaho

don't remember with stock tray but with j&m amp tray and round hole cut off stock bracket i could fit two in there if needed to.have had jl280/4 nvx4 and now cerwin b54 in there.