Bridging the Stinger?
Thanks.
Figured that was the case. I'm using the Stinger to power my 8.8" JLs. I've got it bridged, and only used 2 inputs. Power seemed right when checking output voltage. Just wanted to make sure I wasn't leaving anything on the table. Trying to squeeze every last drop out of my system before I make a decision to do any upgrades.
Same goes for my Mmats and DB Moto G2s off the TX48. Planning to do a bit more fine tuning to see if I have left anything on the table. Figure I might be able to squeeze a little more out of the JLs, the Mmats and DB Motos. Probably pushing a few boundaries, so hoping I don't see any white smoke, lol.
Figured that was the case. I'm using the Stinger to power my 8.8" JLs. I've got it bridged, and only used 2 inputs. Power seemed right when checking output voltage. Just wanted to make sure I wasn't leaving anything on the table. Trying to squeeze every last drop out of my system before I make a decision to do any upgrades.
Same goes for my Mmats and DB Moto G2s off the TX48. Planning to do a bit more fine tuning to see if I have left anything on the table. Figure I might be able to squeeze a little more out of the JLs, the Mmats and DB Motos. Probably pushing a few boundaries, so hoping I don't see any white smoke, lol.
I'll have to throw the meter on it to see where I am now that I've been playing with gains on the DSP lately, but I should still be sitting fairly close to 250 still, maybe a little more.
Thread
Thread Starter
Forum
Replies
Last Post
