2011 CVO audio issues
Seasoned HDF Member
Joined: Jan 2005
Posts: 5,847
Likes: 2,495
From: Lake Orion, MI
I am certain you checked this- but, just in case.
1. Plug your wired headset it and make sure you have the setting directed to the headset. Are you getting anything in the helmet?
2. Double check your settings - make sure they are directed to your speakers.
1. Plug your wired headset it and make sure you have the setting directed to the headset. Are you getting anything in the helmet?
2. Double check your settings - make sure they are directed to your speakers.
Ok so sorry I haven't replied feeling stupid so let me explain 1st thanks for all the help the bike is 100% back everything working back to normal so what was wrong I said a few times I checked all fuses all were good at least I thought I was about to switch the relay just to see if it was that right over the relay is the 20amp fuse that I swear I checked not sure if just didn't look closely cause I took it out to get to the relay easier and noticed a small discolored dot right at the edge I just got batteries for my voltage meter so checked the Continuity and Sure it enough the fuse was bad replaced it and everything back to normal on the up side I did learn alot and really appreciate everyone's help as of right now only issue I have is my abs light is steady on but brakes seem to be working fine
Seasoned HDF Member
Joined: Dec 2017
Posts: 5,075
Likes: 3,293
From: Plover, WI
Ok so sorry I haven't replied feeling stupid so let me explain 1st thanks for all the help the bike is 100% back everything working back to normal so what was wrong I said a few times I checked all fuses all were good at least I thought I was about to switch the relay just to see if it was that right over the relay is the 20amp fuse that I swear I checked not sure if just didn't look closely cause I took it out to get to the relay easier and noticed a small discolored dot right at the edge I just got batteries for my voltage meter so checked the Continuity and Sure it enough the fuse was bad replaced it and everything back to normal on the up side I did learn alot and really appreciate everyone's help as of right now only issue I have is my abs light is steady on but brakes seem to be working fine
If so, you may want to repost your reply in the correct thread as an update to those that offered advice in the thread you started.
Last edited by barneyboy; Dec 30, 2022 at 02:01 PM.
thanks for letting me know
Thread
Thread Starter
Forum
Replies
Last Post
JmRz2
Screamin Eagle CVO Models
0
May 4, 2012 09:42 PM
