What should I do different
Thread Starter
|
Stage IV
Joined: Aug 2022
Posts: 4
Likes: 0
From: NE
What should I do different
have a 07 ultra with Fosgate 6.5 in the tour pack Fosgate 6s in the fairing and diamond audio mp694 in the lids the mp694 are running off a Fosgate m5 800x4 bridged and the mp694s sound horrible they crack and distorte so I took them back out and put my Fosgate 6x9s back in and they sound ok but not the lows I’m looking for why are the diamond audios sounds so bad any advice would help
Road Master
Joined: Mar 2021
Posts: 852
Likes: 374
From: Toledo, Ohio
How do you have them wired? What they crossed over at? HP? What frequency? What volts you set the gains?
The tweeter is 8ohm and the speaker is 4ohm. Not sure how you have them but that amp is only capable of 4ohm bridged.
The tweeter is 8ohm and the speaker is 4ohm. Not sure how you have them but that amp is only capable of 4ohm bridged.
Last edited by kloccwork419; Aug 3, 2022 at 11:22 AM.
Thread Starter
|
Stage IV
Joined: Aug 2022
Posts: 4
Likes: 0
From: NE
have a 07 ultra with Fosgate 6.5 in the tour pack Fosgate 6s in the fairing and diamond audio mp694 in the lids the mp694 are running off a Fosgate m5 800x4 bridged and the mp694s sound horrible they crack and distorte so I took them back out and put my Fosgate 6x9s back in and they sound ok but not the lows I’m looking for why are the diamond audios sounds so bad any advice would help
Thread Starter
|
Stage IV
Joined: Aug 2022
Posts: 4
Likes: 0
From: NE
Last edited by Josh-M/74; Aug 3, 2022 at 12:51 PM.
Road Master
Joined: Mar 2021
Posts: 852
Likes: 374
From: Toledo, Ohio
Gains at 1 oclock doesn’t tell anyone anything. They need to be set by volts. Look at the amp gains sticky in the audio section. Recheck your wiring with the manual and maybe set the crossover to 100-125hz. Find out whats cracking. Unhook the tweeter and see how it sounds. Do you have the 4ohm resistor installed too?
Thread
Thread Starter
Forum
Replies
Last Post
