Biltwell 10" Risers
Biltwell 10" Risers
Thinking about making this switch to get a better bar height rather than going with west coast t's. I am also assuming since they are just risers it would be a simple swap? No electrical splicing? Is this a bolt on mod or is there more to it?
Stock risers on the FXDF are 5.5". Would I need to look at new cables?
http://www.jpcycles.com/product/724-385
Stock risers on the FXDF are 5.5". Would I need to look at new cables?
http://www.jpcycles.com/product/724-385
Road Captain
Joined: Jun 2014
Posts: 508
Likes: 31
From: California
I have the Biltwell 10 inchers. Simple swap, you shouldn't have to get new cables unless you go above 12", but measure how much slack your cables have anyway. Easier to measure once than re-order twice.
Road Captain
Joined: Dec 2013
Posts: 539
Likes: 5
From: Harleyland, USA
On my 2005 Low Rider I tried to put 8" curved risers instead of stock 4" curved risers and brake line was simply too short and cables were quite tight. Although I installed +4" brake line, I ended up installing 6" curved riser.
Tourer
Joined: Apr 2013
Posts: 286
Likes: 0
From: Bay Area, Cali
Also check out bungking.com, the have nice risers that can be internally wired for a good price. Made in the USA too!
Thread
Thread Starter
Forum
Replies
Last Post
